MIL-L-87177A
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) ASTM B 117 Method of Salt Spray (Fog) Testing (DoD adopted) ASTM D 740 Methyl Ethyl Ketone
ASTM D 877 Dielectric Breakdown Voltage of Insulating Liquids Using Disk
Electrodes (DoD adopted)
ASTM D 942 Oxidation Stability of Lubricating Greases by the Oxygen Bomb
Method (DoD adopted)
ASTM D 1310 Flash Point of Liquids by Tag Open-Cup Apparatus (DoD adopted) ASTM D 2266 Wear Preventive Characteristics of Lubricating Grease (Four-Ball
Method) (DoD adopted)
(Applications for copies should be addressed to American Society for Testing and
Materials, 1916 Race Street, Philadephia, PA 19103-1137.)
DEPARTMENT OF TRANSPORTATION
29 CFR 1910.2100 Material Safety Data Sheet, Preparation and Submission of
49 CFR 173.300 Department of Transportation Hazardous Materials Regulation
(Application for copies should be addressed to Department of Transportation, 400 7th
Street, SW, Washington, DC 20590.)
(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents. These documents also may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specified exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2.2.1), a sample shall be subjected to first article inspection in accordance with 4.4.
3.2 Material safety data sheet. Material safety data sheets shall be prepared in accordance with FED-STD-313 and 29 CFR 1910.2100. When FED-STD-313 is at variance with the CPR, 29 CFR 1910.2100 shall take precedence, modify and supplement FED-STD-313.
3.3 Properties. The compound shall conform to the properties specified in table I.
3.3.1 Type I compound. The type I compound (See table I) shall be contained in a gas pressurized container with a 80 percent volume of the compound and 2.7 percent volume of carbon dioxide.
3.3.2 Type II compound. The type II compound (see table I) shall be in bulk form.
3.3.3 Type packaging
3
Source: https://assist.dla.mil -- Downloaded:
Check the source to verify that this is the current version before use.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business