MIL-DTL-85694A
10 ppm, 30 ppm, 50 ppm, 80 ppm, 100 ppm, 120 ppm, 300 ppm, 500 ppm, 700 ppm, and 900
ppm.
3.3.3 Type D12-XXX. Type D12-XXX spectrometric oil standard (SOS) shall meet the
requirements specified in Table I and contain the elements at the appropriate concentrations as
listed for Type D12 standards in Table II. Nominal concentrations for D19 standards are 5 ppm,
10 ppm, 30 ppm, 50 ppm, 100 ppm, and 300 ppm.
3.3.4 Type D3-100. Type D3-100 spectrometric oil standard (SOS) shall meet the
requirements specified in Table I and contain the elements at the concentration of 100 ppm
as listed for Type D3 standards in Table II.
3.3.5 Type D21-XXX. Type D21-XXX spectrometric oil standard (SOS) shall meet the
requirements specified in Table I and contain the elements at the appropriate concentrations as
listed for Type D21 in Table II. Nominal concentrations for D21 standards are 5 ppm, 10 ppm,
30 ppm, 50 ppm, 80 ppm, 100 ppm, 120 ppm, 300 ppm, 500 ppm, 700 ppm, and 900 ppm.
3.4 Homogeneity. All blended spectrometric oil standards shall be homogeneous, free of
sediment or precipitate and shall not indicate any mirroring or silvering appearance from the
silver element.
3.5 Spectrometric oil standards stability. The spectrometric oil standards shall have a shelf
life stability of not less than 30 months for Types D12-XXX and D19-0 and not less than 12
months for Types D19-XXX, D21-XXX, and D3-100. Shelf life beyond the above limits shall be
established on laboratory test data (see 6.3).
3.6 Toxicity. The spectrometric oil standards shall have no adverse effect on the health of
personnel when used for its intended purpose in accordance with the safety standards issued by
the Occupational Safety and Health Administration (OSHA) (see 6.5 and 6.6).
3.7 Properties. Spectrometric oil standards shall meet all of the requirements of this
specification when tested as specified in Table I and 4.4.1 through 4.4.2.
3.8 Unit pack. Spectrometric oil standards shall meet all of the unit pack requirements of this
specification as specified in 3.8.1 through 3.8.3.
3.8.1 Containers. Natural high-density polyethylene cylinder bottles with 24/410 neck finish,
8 ounce capacity, shall be used. The bottles shall have a 24/410 white polypropylene unlined flip
top cap and a 24/410 natural unlined low-density polyethylene Yorker cap with red tip.
3.8.2 Packing. The natural high-density polyethylene cylinder bottles shall be packed in Kraft
mailing tubes with end caps (2.5″ x 7″ x 0.060″).
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business