VV-G-671G
ASTM D566 - Dropping Point of Lubricating Grease
ASTM D2266 - Wear Preventive Characteristics of Lubricating Grease
(Four-Ball Method)
ASTM D2596 - Measurement of Extreme Pressure Properties of
Lubricating Grease (Four-Ball Method)
ASTM D4048 - Detection of Copper Corrosion from Lubricating Grease
ASTM D4057 - Manual Sampling of Petroleum Products, Standard Practice for
(Copies of these documents are available from www.astm.org or ASTM International, P.O. Box C700, West Conshohocken, PA 19428-2959.)
AMERICAN SOCIETY FOR QUALITY (ASQ)
ANSI/ASQ Z1.4 - Sampling Procedures and Tables for Inspection by
Attributes
(Copies of this document are available from www.asq.org or American Society for Quality,
600 North Plankinton Avenue, Milwaukee, WI 53203.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Material Safety Data Sheets. The contractor shall certify that no carcinogenic or potentially carcinogenic constituents are present as defined under the Hazard Communication Standard (HCS) (29 CFR 1910.1200). Certification to this effect shall be made available to the contracting officer or the contracting officer's designated representative. When awarded a contract, the manufacturer shall submit to the contracting officer or designated representative Material Safety Data Sheets prepared in accordance with FED-STD-313 and CFR 1910.1200. When FED-STD-313 varies from the CFR, 29 CFR 1910.1200 shall take precedence, modify and supplement with FED-STD-313.
3.2 Materials. The grease shall consist of a mineral lubricating oil (virgin or refined oil) thickened with a calcium soap of one or more of the higher fatty acids and sufficient graphite of a particle size conforming to DOD-G-82673, and quality of 98 percent purity (see 6.3) to meet the requirements. The grease may also contain additives as necessary to meet these requirements.
3.2.1 Toxic products and formulations. The grease shall have no adverse effect on the health of personnel when used for its intended purpose. The grease shall contain no components which produce noxious vapors in such concentrations as to be an annoyance to personnel during formulation or normal use under conditions of adequate ventilation while exercising caution to
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business