VV-G-632 Grease, Industrial, General Purpose S/S By Mil-Prf-10924This specification covers one grade of a lubricating grease intended primarily for the lubrication of machinery which is equipped with compression type grease cups see 6.8.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9

VV-G-632B

Military Standards:

MIL-STD-105            - Sampling Procedures and Tables for Inspection by Attributes.

MIL-STD-129            - Marking for Shipment and Storage. MIL-STD-147            - Palletized Unit Loads.

MIL-STD-290            - Petroleum and Related Products, Packaging of.

(Unless otherwise indicated, copies of federal and military specifications, standards, and handbooks are available from the Naval Publications and Forms Naval Publications and Center, (ATTN;  NPODS), 5801 Tabor Avenue, Philadelphia, PA 19120-5099.)

2.1. 1 Other Government document.  The following other Government document forms a part of this document to the extent specified herein.  Unless otherwise specified, the issues are those cited in the solicitation.

DEPARTMENT OF LABOR (DOL)

OSHA 29 CFR 1910.1200 - Hazard Communication Interpretation Lubricating Oils. (Guideline CPL 2-2.38 may be obtained from OSHA Publication Office, Room S-4203,

200 Constitution Avenue, NW, Washington, DC 20210.)

2.2  Non-Government publications.  The following document(s) form a part of this document to the extent specified herein.  Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue of the DODISS cited in the solicitation.  Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).

American Society for Testing and Materials (ASTM) Standards:

D 92        -  Flash and Fire Points by Cleveland Open Cup.

D 95        -  Water in Petroleum Products and Bituminous Materials by Distillation. D 97        -  Pour Point of Petroleum Oils.

D 128      -  Analysis of Lubricating Grease.

D 217      -  Cone Penetration of Lubricating Grease.

D 445      -  Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of

Dynamic Viscosity).

D 566      -  Dropping Point of Lubricating Grease. D 1500    -  Color of Petroleum Products.

D 4048    -  Detection of Copper Corrosion from Lubricating Grease by the Copper Strip

Tarnish Test.

D 4057    -  Manual Sampling of Petroleum Products, Standard Practice for.

(Application for copies should be addressed to the American Society for Testing and Materials,

1916 Race Street, Philadelphia, PA 19103.)

2