MIL-PRF-27601C
2.3 Non-Government publications. The following document(s) form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of the documents that are DoD adopted are those listed in
the issue of the DoDISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in
the DoDISS are the issues of the documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM D 92
-
Flash and Fire Points by Cleveland Open Cup, Standard Test Method for (DoD
adopted)
ASTM D 97
-
Pour Point of Petroleum Oils, Standard Test Method for (DoD adopted)
ASTM D 130
-
Copper Corrosion from Petroleum Products by the Copper Strip Tarnish Test,
Standard Method for Detection of (DoD adopted)
ASTM D 445
-
Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation
of Dynamic Viscosity), Standard Test Method for (DoD adopted)
ASTM D 664
-
Neutralization Number by Potentiometric Titration, Standard Test Method for
(DoD adopted)
ASTM D 892
-
Foaming Characteristics of Lubricating Oils, Standard Test Method for (DoD
adopted)
ASTM D 1298
-
Density, Relative Density (Specific Gravity), or API Gravity of Crude
Petroleum and Liquid Petroleum Products by Hydrometer Method, Standard
Test Method for
ASTM D 1744
-
Water in Liquid Petroleum Products by Karl Fischer Reagent, Standard Test
Method for (DoD adopted)
ASTM D 4057
-
Manual Sampling of Petroleum and Petroleum Products, Standard Practice for
ASTM D 4172
-
Wear Preventive Characteristics of Lubricating Fluid (Four-Ball Method),
Standard Test Method for
ASTM D 4177
-
Automatic Sampling of Petroleum Products, Standard Test Method for (DoD
adopted)
ASTM D 4636
-
Corrosiveness and Oxidation Stability of Hydraulic Oils, Aircraft Turbine
Engine Lubricants, and Other Highly Refined Oils, Standard Test Method for
ASTM D 4898
-
Insoluble Contamination of Hydraulic Fluids by Gravimetric Analysis,
Standard Test Method for
ASTM D 5306
-
Linear Flame Propagation Rate of Lubricating Oils and Hydraulic Fluids,
Standard Test Method for
ASTM F 312
-
Microscopical Sizing and Counting Particles from Aerospace Fluids on
Membrane Filters
(Application for copies should be addressed to the American Society for Testing and Materials, 100 Barr Harbor
Drive, West Conshohocken, PA 19428-2959.)
AEROSPACE MATERIAL SPECIFICATIONS (AMS)
AMS 3217/4
-
Test Slabs, Fluoroelastomer (FKM), 65-75
(Applications for copies should be addressed to Society of Automotive Engineers (SAE), 400 Commonwealth Dr.,
Warrendale PA 15096-0001.)
(Non-Government standards and other publications are normally available from the organizations that prepare or
distribute the documents. These documents also may be available in or through libraries or other informational
services.)
2.4 Order of Precedence. In the event of a conflict between the text of this document and the references cited
herein (except for related associated detail specifications, specification sheets, or MS standards), the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless
a specific exemption has been obtained.
3