MIL-PRF-63460 Lubricant, Cleaner And Preservative For Weapons And Weapons SystemsThis specification describes the performance requirements and verification methods for a type of LUBRICANT, CLEANER AND PRESERVATIVE FOR WEAPONS AND WEAPONS SYSTEMS. This product is for use in cleaning, lubricating and short-term \(see 6.9.5\) preservation of small and large caliber military weapons, operating in the temperature range of -51 to +71 degrees C \(-60 to +160 degrees F\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

'Working � 2 March 2006' by Tremblay, Raymond P. - Page 3 of 16

MIL-PRF-63460E

2.3 Non-Government publications. The following documents form a part of this document to

the extent specified herein. Unless otherwise specified, the issues of these documents are those

cited in the solicitation or contract.

ASTM INTERNATIONAL

ASTM A109/A109M Standard Specification for Steel, Strip, Carbon, (0.25 Maximum

Percent), Cold-Rolled

ASTM B16/B16M

Standard Specification for Free-Cutting Brass Rod, Bar and

Shapes for Use in Screw Machines

ASTM B152/B152M Standard Specification for Copper Sheet, Strip, Plate and

Rolled Bar

ASTM B209

Standard Specification for Aluminum and Aluminum-Alloy Sheet

and Plate

ASTM D56

Standard Test Method for Flash Point by Tag Closed Cup Tester

ASTM D92

Standard Test Method for Flash and Fire Points by Cleveland Open

Cup Tester

ASTM D97

Standard Test Method for Pour Point of Petroleum Products

ASTM D445

Standard Test Method for Kinematic Viscosity of Transparent and

Opaque Liquids (and the Calculation of Dynamic Viscosity)

ASTM D972

Standard Test Method for Evaporation Loss of Lubricating Greases

and Oils

ASTM D1748

Standard Test Method for Rust Protection by Metal Preservatives

in the Humidity Cabinet

ASTM D4057

Standard Practice for Manual Sampling of Petroleum and

Petroleum Products

ASTM D4172

Standard Test Method for Wear Preventive Characteristics of

Lubricating Fluid (Four-Ball Method)

ASTM D4177

Standard Practice for Automatic Sampling of Petroleum and

Petroleum Products

ASTM D5620

Standard Test Method for Evaluating Thin Film Fluid Lubricants

in a Drain and Dry Mode Using a Pin and Vee Block Test Machine

(Copies of these documents may be ordered at www.astm.org or from the ASTM International,

100 Barr Harbor Drive, West Conshohocken, PA 19428-2959)

SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)

AMS 4376

Plate, Magnesium Alloy 3.0 Al � 1.0 Zn � 0.20 Mn (AZ31B-H26)

Cold Rolled and Partially Annealed

(Copies of this document may be ordered on line at www.sae.org or from the SAE World

Headquarters, 400 Commonwealth Drive, Warren dale, PA 15096)

2.4 Order of precedence. In the event of a conflict between the text of this document and

the references cited herein, the text of this document takes precedence. Nothing in this

document, however, supersedes applicable laws and regulations unless a specific exemption has

been obtained.