MIL-PRF-18458C
manufacturers are urged to arrange to have the products that they propose to
offer to the Federal Government tested for qualification in order that they
may be eligible to be awarded contracts or purchase orders for the products
covered by this specification. Information pertaining to qualification of
products may be obtained from the Naval Sea Systems Command, ATTN: SEA 05Q2,
1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160.
6.4
Definitions.
6.4.1 Lot. For purposes of sampling, a lot consists of all grease
manufactured in a single plant run (not exceeding 24 hours), through the same
processing equipment, with no change in the ingredient materials.
6.4.2 Bulk lot. An indefinite quantity of a homogenous mixture of
grease offered for acceptance in a single, isolated container; or manufactured
in a single plant run (not exceeding 24 hours), through the same processing
equipment with no change in the ingredient materials.
6.4.3 Packaged lot. An indefinite number of drums or smaller unit
containers of identical size and type, offered for acceptance, and filled with
a homogenous mixture of grease manufactured in a single plant run (not
exceeding 24 hours), through the same processing equipment with no change in
the ingredient materials.
6.5 Toxicity evaluation. Questions concerning toxicity and requests
for Health Hazard Risk Assessments (HHRA) should be addressed to Commanding
Officer, Navy Environmental Health Center, 620 John Paul Jones Circle, Suite
1100, Portsmouth, Virginia 23513-2617, Attention: C.I.H./NEHC-34. NEHC
requires sufficient information to permit a toxicological evaluation of the
product. As a minimum, the information should include approximate
percentages by weight of each ingredient in the product; identification of its
pyrolysis products; and any such other information as may be needed to permit
an accurate appraisal of any toxicity problems associated with the handling,
storage, application, use, disposal, or combustion of the product. Upon
receipt of the HHRA performed by NEHC, a copy should be provided to Commander,
Naval Sea Systems Command, ATTN: SEA 05M, 1333 Isaac Hull Avenue, SE, Stop
5130, Washington Navy Yard DC 20376-5130.
6.6
Part or identifying number (PIN). The PINs to be used for wire
rope and exposed gear grease acquired to this specification are created as
follows:
Example:
M 18458-1
Type
Specification
Subject term (key word) listing.
6.7
Corrosion protection
Lubricant
Open gear
Preservation
Weather resistant
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business