VV-L-825C
11 Discoloration of test strip shall be not greater than that caused by oxidation of a blank copper strip when exposed to dry heat oven at 212 F (100 C) for 3 hours.
21 FED-STD-791 for bearing tests need not be run when there is a change in approved base oils only and the originally approved additive package is retained to formulate the oil.
31 Journal speed - 3500 revolutions per minute, bearing temperature:
150 + 1 F (51.3 + 0.55 C).
41 Pass if there is no evidence of corrosion such as deposit or discolaration.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or purchase order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3 and 5. The inspection set forth in this specification shall become a part of the contractor's overall inspection system or quality program. The absence of any inspection requirements in the specification shall not relieve the contractor of the responsibility of assuring that all products or supplies submitted to the Government for acceptance comply with all requirements of the contract. Sampling in quality conformance does not authorize submission of known defective material, either indicated or actual, nor does it commit the Government to acceptance of defective material.
4.2 Classification of inspections. The inspection requirements specified herein are classified as follows:
(a) Qualification inspection (see 4.3).
(b) Quality conformance inspection (see 4.4).
4.3 Qualification inspection. Qualification inspection shall be conducted at a laboratory satisfactory to the Naval Sea Systems Command. Qualification tests shall consist of tests for the requirements specified in table I (see 3.5).
4.4 Quality conformance inspection. Quality conformance inspection shall be in accordance with method 9601 of FED-STD-791. Lot determination shall be as specified in 4.4.1. Each sample selected as specified in 4.4.2 shall be subjected to the tests as specified in table I, except the bearing compatibility, chemical stability and journal bearing tests are not required. However, any additional tests deemed necessary by the contracting activity to determine conformance to this specification may be required.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business